北京pk10赛车开奖记录结果

HomeTechnical support ◇ Blades of kitchen waste grinder improve production efficiency
Blades for food waste shredders increase productivity
  • Release date: 2019-12-24 Source: Views: 22
    • The kitchen garbage shredder is a small machine placed at the connection between the kitchen sink and the pipeline. The high-speed rotating motor drives the turntable in the grinding chamber to allow the food waste to collide with each other under the action of centrifugal force, and the food is crushed in a very short time. The garbage is ground into fine particles and discharged out of the pipe along the water. Generally, it can handle food waste: leftovers, leftovers, leaves, peels, eggshells, tea residue, bones, shells, etc. The kitchen garbage shredder is also very convenient to install and use. Just install the machine below the sink, the top is connected to the drain of the sink, and the bottom is connected to the drain pipe. Each time the power is turned on, the crushing impeller can crush the kitchen waste. , Rushed into the sewer along the water.

      The blades of the kitchen garbage shredder are easy-to-wear parts. One set needs to be replaced after a period of use. The replacement of the blades can improve the quality and quantity to improve production efficiency. Failure to replace the worn blades in time will lead to uneven garbage crushing, reducing yield and crushing. quality. Garbage shredders must also pay attention to maintenance and maintenance. When replacing the blade, stop and cut off the power. When the blade is not sharp, sharpen the blade in time. If the garbage crusher blade is severely worn, replace it with a new one, install and adjust the blade, adjust the blade height, the blade edge of the flat blade is exposed to the disc, and after adjusting the vertical height, tighten the knife bolt to prevent blade movement. , Damage to the machine.
      For the adjustment of the fixed knife, the gap between the fixed knife and the movable knife should be adjusted to 1 to 2 mm. After replacing the blade, check whether the bolts in all parts are tight. If they are loose, tighten them. Turn the pulley by hand. There should be no friction between the machine parts and the case to ensure safety.
      After the machine is turned on, the machine can be fed only when the machine runs at a normal speed. Do not start with the machine. When starting the machine, do not put your hand deep into the feed port to prevent your hands from being injured. If there is an abnormal sound during the machine, stop the machine and check for trouble to avoid damage Machine. The operator should not stand in the center of the feeding opening, and should feed sideways to prevent accidents.

    • Phone:
      13818203501
    Scan to visit the mobile station Scan to visit the mobile station
    Visit mobile station